Cutting Force in Microcutting of Steel Using Superabrasive Single Grains (1st Report)

Seimitsu Kogaku Kaishi/Journal of the Japan Society for Precision Engineering - Japan
doi 10.2493/jjspe.60.378
Full Text
Abstract

Available in full text

Date
Authors
Publisher

Japan Society for Precision Engineering

Related search

Investigation of Cutting Force in Hardened Steel Turning

Scholarly Notes of Komsomolsk-na-Amure State Technical University
2016English

Experimental Research on Milling Operations : 1st Report, on the Optical Method of Cutting Force Measurement

Transactions of the Japan Society of Mechanical Engineers
1967English

Fracture Mechanism of Cermet Tools in Intermittent Cutting (1st Report)

Journal of the Japan Society of Precision Engineering
1982English

Optimization of Cutting Force of Turning of AISI 1018 Mild Carbon Steel Using RSM

International Journal of Trend in Scientific Research and Development
2018English

Plasticity Analysis of Cutting Process With Abrasive Grain (1st Report)

Journal of the Japan Society of Precision Engineering
1978English

Investigation on Cutting of Fibre Reinforced Composite Material. (1st Report). Improvement of Surface Finish in Cutting GFRP.

Seimitsu Kogaku Kaishi/Journal of the Japan Society for Precision Engineering
Mechanical Engineering
1989English

Steel Cutting Using Abrasive Water Jet

2017English

Using of Fem for Chip Formation and Cutting Force Prediction When Drilling Tool Steel Aisi D3

MM Science Journal
Electronic EngineeringIndustrialMechanical EngineeringAutomotive EngineeringManufacturing EngineeringElectrical
2011English

Cutting Force Modelling With Effects of Cutting Tool Geometry and Tool Wear in Milling of Din C45 Steel

MM Science Journal
Electronic EngineeringIndustrialMechanical EngineeringAutomotive EngineeringManufacturing EngineeringElectrical
2020English

Amanote Research

Note-taking for researchers

Follow Amanote

© 2024 Amaplex Software S.P.R.L. All rights reserved.

Privacy PolicyRefund Policy